How To Install Uppababy Mesa Infant Insert

• Contents
• Table of Contents
• Bookmarks

• three

  Certification

• 3

  Use Recommendations

• 3

  Before You Brainstorm

• vii

  Warnings + General Prophylactic Instructions

• vii

  Rear-Facing Seat Features

• 9

  Vehicle Compatibility

• 12

  Base Installation with Lower Anchors

• 12

  Leveling Base

• 13

  Base Installation with Vehicle Seat Belt

• 17

  Full general Use

• 21

  Stroller Compatibility

• 22

  Care + Maintenance

• 25

  Cleaning

  Also See for UPPAbaby mesa

  Related Manuals for UPPAbaby mesa

  Summary of Contents for UPPAbaby mesa

• Folio i From 4-35 lbs...

• Folio 2: Tabular array Of Contents

  Table OF CONTENTS Read all instructions earlier use of the rear-facing car seat. Keep instruction book for future use. (Storage pocket located on underside of base of operations.) BEFORE Yous Begin CERTIFICATION USE RECOMMENDATIONS REGISTRATION Observe OF EXPIRATION WARNINGS + GENERAL Safety INSTRUCTIONS REAR-FACING SEAT FEATURES OVERVIEW OF Base OVERVIEW OF CARRIER...

• Folio 3: Certification

  Motor Vehicle Safety Standards (FMVSS). LEVELING THE CARRIER DETERMINING BEST INSTALLATION METHOD This child restraint is certified for aircraft apply. UPPAbaby and LAP/SHOULDER BELT STANDARD ROUTING METHOD the Federal Aviation Assistants (FAA) strongly urge you to INSTALLATION WITH LOCKING Prune...

• Folio iv: Registration

  CARRIER BASE installing this kid restraint in a seating position UPPAbaby reserves the right to brand blueprint changes and improvements with side airbags. to any of our products equally function of our commitment to innovation. UPPAbaby MESA Instruction Book...
• Page 5 INSTEAD • NEVER hang strings on or over the carrier or identify a blanket over the child after being properly attach to handle. secured in the harness. UPPAbaby MESA Instruction Volume UPPAbaby MESA Instruction Book...
• Folio 6 1 in from the acme of the supplied by other manufacturers with this child headrest when in its highest position. restraint, unless approved and tested by UPPAbaby. Items not tested with this restraint could injure Exercise Not •...

• Folio 7: Overview Of Base

  Lap Belt Simply (page/páge 22) Cinturón de Regazo Solamente LOCKING CLIP VEHICLE Belt LOCK-OFF (CLOSED) FRONT OF VEHICLE FRENTE DEL VEHÍCULO LEVEL WHEN NO Ruby-red VISIBLE LOWER Ballast CONNECTOR Aligning LEVEL ANGLE FOOT INDICATORS (2) STORAGE UPPAbaby MESA Education Volume UPPAbaby MESA Teaching Book...

• Page 8: Production Overview

  HARNESS BUCKLE ANCHORS (two) INFANT INSERT LATCH (RECOMMENDED PLATES (2) CROTCH BUCKLE Between 4-8 LBS) POSITIONS (ii) HARNESS VEHICLE HARNESS ADJUSTER SEAT BELT ADJUSTER RELEASE GUIDES (2) HARNESS ADJUSTER STRAP STRAP HOLDER UPPAbaby MESA Instruction Volume UPPAbaby MESA Education Book...

• Page 9: Choosing A Vehicle Seating Location

  If the MESA does not install best in the rear middle seating location, information technology is recommended to move to one of the outboard seating positions.

• Page 10: Overview Of Latch

  If spacing between the lower anchors is greater than 22 in or if the seating position is non approved by the vehicle manufacturer then use the vehicle seat belt for installation. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book...

• Page 11: Unsafe Vehicle Seat Chugalug Systems + Seating

  Door mounted Inflatable DO Non use this child restraint with the following vehicle seats: Vehicle seats that confront rear of the vehicle Vehicle seats that face up side of the vehicle UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book...

• Folio 12: Base of operations Installation With Lower Anchors

  STEP 1: Press the red push button on the lower anchor connector while downward push is discontinued. pulling the connector off the vehicle ballast STEP 2: Shop lower ballast connectors in designated housing found on each side of the base. UPPAbaby MESA Pedagogy Volume UPPAbaby MESA Teaching Book...

• Page 13: Leveling Base

  If move is more 1 in, twist the buckle and then fasten the seat belt to help secure fit. Securing the Base (Lap Belt Only Installation)–pg. 24, steps 4B-6B. UPPAbaby MESA Instruction Book UPPAbaby MESA Pedagogy Volume...

• Folio 14: Securing The Base (Lap Belt Just Installation)

  Notation: Check that the base doesn't motion more 1 in side to side at the belt path. If move is more one in, twist the buckle and then fasten the seat belt to assist secure fit. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Volume...

• Folio 15: Leveling The Carrier

  (keep to pg. 27) LAP ONLY METHOD: No shoulder chugalug is used. This method applies to vehicle with no shoulder belt and shipping. (go on to pg. 29) UPPAbaby MESA Instruction Book UPPAbaby MESA Teaching Book...

• Folio 16: Installation With Locking Clip

  • Angle is correct when the vehicle is parked on level ground and the red line on the carrier is level to the vehicle floor • Seating position is permitted by both UPPAbaby and your vehicle manufacturer for utilize with the type of Vehicle Seat Chugalug.

• Page 17: Shipping Installation

  The crotch chugalug and buckle has two apply positions. Always position the buckle and crotch strap in the slot closest to the kid. If the kid is on top of the UPPAbaby and the Federal Aviation Administration (FAA) buckle in the inner position, and then adjust the buckle to the outer position.

• Page 18: Infant Insert (Recommended iv-viii Lbs)

  Step 2: Open the retainer clip, Annotation: Never use non-regulated products with unbuckle the harness, and constrict this child restraint, unless canonical by UPPAbaby. the latch plates into the side pockets to hold harness open. Pace three: Identify infant in child restraint...

• Folio 19: Pinch Exam

  If you tin can pinch STEP 1: Pull and hold carrier release webbing, the harness is too button on dorsum of the carrier. loose and should be tightened. Stride 2: Elevator carrier off base. UPPAbaby MESA Pedagogy Book UPPAbaby MESA Instruction Book...

• Folio xx: Hide-Away Canopy

  These products take not been • Ever check the tightness indicator is green after each apply. tested past UPPAbaby and therefore are not approved for • Always secure an unoccupied child restraint; in a crash an unsecured infant auto seat may injure occupants in your vehicle.

• Folio 21: Plumbing equipment Carrier To Stroller Frame

  NOTE: VISTA 2022 and earlier stroller models require adapters for Stride 1: With carrier facing stroller use with the MESA. Please contact UPPAbaby Customer Service at handle, align carrier handle hubs 781.413.3030 for your costless adapter.

• Page 22: Fitting Carrier To Vista 2022 And Earlier Frame Adapters

  STEP 3: Pull SIP padding down from bottom and release. STEP 1: Appoint and hold the stroller release push button on the peak of the carry handle. STEP 2: Elevator the carrier off the adapters on stroller frame. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Volume...

• Page 23: Seat Padding Removal

  Step four: Loosen padding from front end of carrier and free padding from around harness adjuster release push housing. Step v: Raise SIP to highest position and pull dorsum padding panel. UPPAbaby MESA Instruction Book UPPAbaby MESA Education Volume...

• Page 24: Seat Padding Installation

  STEP 4: Feed buckle through buttonhole in seat padding. Step 10: Reconnect harness adjuster strap. Footstep 5: Install buckle cover tucking tabs through buttonhole. Pace 6: Raise the SIP and place buckle in harness holder pockets. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book...

• Page 25: Sip Padding Installation

  CLEANING BUCKLE AND LOWER Ballast CONNECTOR HARDWARE NOTE: Buckle should fasten with a "click" if not, rinse under warm running water. DO Non use detergents or lubricants. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book...

• Folio 26: Limited Warranty

  Weather condition may vary. UPPAbaby will non transport replacement or repair parts out of the country of buy. UPPAbaby will provide replacement parts or deport repairs as determined fitting by the visitor.
• Folio 27 All rights reserved. © 2022 UPPAbaby. UPPAbaby and all associated logos are trademarks. All product specifications are correct at time of print. UPPAbaby reserves the correct to change anything at any time without prior notice. Color representation is as close as print processes allow. Not all colors available at all retailers.

Source: https://www.manualslib.com/manual/1029036/Uppababy-Mesa.html

Posted by: garciaeary1996.blogspot.com

Share this post